Anyone know of a good Ryobi press technician. We are having problems with a 524GE and need a knowledgeable serviceman to look into it. We've tried Xpedx but have been getting the runaround for parts and service from them. My next thought would be to go to Ferrostaal but thought I would check out...
Forums Press Technology Sheetfed/Web Offset Discussion Ryobi 524 perfector error on startup. millennialprinter
We just installed our Ryobi 3302H, and the press does not feed paper into the grippers. It´s picking up paper just fine but when it arrives to the push guide it stops right there and refuses to feed. Any thing we can try to get it to feed? We are not very familiar with this press.
I'm having problems getting the registration to hold on a Ryobi 3302. I can get the press to register for about a 100 sheets or so but then the registration starts to bounce. We have had this press for about 4 months now, we bought it from our service tech, and since he is not a printer I got...
Ryobi 5ply blanket at 2.5mm thickness (compressible) All form lines on the plate are 3.5mm, except water form 4mm to spec Had to open the side panel and adjust the blanket to impression pressure in order to print on 24lb paper. as compared to the thick envelopes; was this wrong? My questions:
Re: Heidelberg SM 52 vs. Ryobi 525 GX Having run a variety of press old and new, The SM52 will give your a lot of versatility. our Configuration is a 6 Color perfector (4/2) with Aq Coater. Fast make ready for your short run stuff 1000 sheets or less. 15,000 sph production with non stop feeder and delivery For your longer runs. I believe the new machines come with the "Mechanic in the Box ...