FANUC 31i-B5 5-Axis VMC and FANUC 31i-B 4-Axis HMC are what I'm looking at at the moment. I've got a few FANUC Manuals and none have 5109 listed that I can find. That Parameter Section however relates to Canned Cycles. So unless you're doing some sort of Canned Cycle, that parameter may not be the answer. I'll poke around and see what I can dig up.
They are FANUC functions/codes. They should be present it your yellow FANUC Manuals. #19700-#19705 information is in the Parameter Manual (30i/31i-B Series - B-64490EN_03) G43.4, G54.4, and G68.2 are in the FANUC Common to Machining Center/Lathe Operator Manual (s) (30i/31i-B Series - B-64484EN_03) HTH
I have a new machine with a Fanuc 0iMc control I bought it with 120 blocks of look ahead in order to contour and surface at higher feed rates. Could someone please give me an explaination of how to get this to work? I have been reading the manual and it tells me to use a G8. An examle of some cod...
I would suggest you contact Fanuc to order copies of their manuals for a 31i control. Typing out a list of G-Codes is not going to help you understand how to use and apply those codes.
Hello everyone I am working with a Fanuc Robodrill equipped with a rotary table (4 and 5 axis) and I have to mill a part taking into account that this milling must be performed along the perpendicular direction of the flat upper surface of the part. In order to do it, The machine is equipped with...
Expand Bumping this as I just tried this on our Mitsubishi with an 18i-MB and I wasn't successful. When I run the main program, I get an "071 data not found" alarm. Any ideas? For what it's worth, this is also the only fanuc control I've ever touched where I can't start a program and go into edit mode to move wherever I want in the program. I have to use GOTO statements for mid-starting ...